Click to enlarge

Gas Mass Flow Switch XGZF7000

5~500L/min;10~1000L/min
Dry Air、N2
LCD Display, 3 Colour, 3 Screen
Measurable Flow Ratio: 100:1
Minimum Flow Increment: 1L/min
Display Layer Rotatable
NPN/PNP Switch Function
Adjustable Response Speed(0.05S~5S)
Pressure-Resistance 12bar
Reliable Quality with Low Cost

Description
SAFETY NOTES & WARRANTY

Description

APPLICATIONS

Equipment Flow Control(Main line and branch line)
Flow Rate or Residual Amount in Gas Cylinder
Spray Painting Flow Control
Semiconductor Equipment Flow Control
Industrial Automation and Process Control

INTRODUCTION

The XGZF7000 is a 3-color 3-screen display flow switch independently developed by CFSensor. Based on MEMS Thermal Element, it is designed for monitoring gas flow rates of dry air, nitrogen (N2). Featuring a 100:1 flow range ratio, this device supports digital filter response speeds as fast as 0.05 seconds. Its display module rotates every 45° to adapt to installation conditions and enhance visibility, and is configurable with various output modes(NPN/PNP and analog output signal). Through modular design and high compatibility, the XGZF7000 series has become a key component in industrial flow management, ideal for industrial automation and energy-saving management scenarios.

DIMENSION (Unit:mm Unspecified Tolerances:±0.2mm)

XGZF7000 DIMENSION

ORDER GUIDE

XGZF7000 ORDER GUIDE

More information about gas mass flow switch XGZF7000, refer to Datasheet or contact CFSensor

XGZF7000 Gas Flow Switch-V1.0.PDF

SAFETY NOTES & WARRANTY

SAFETY NOTES

Using these sensors products may malfunction due to external interference and surges, therefore, please confirm the performance and quality in actual use. Just in case, please make a safety design on the device (fuse, circuit breaker, such as the installation of protection circuits, multiple devices, etc.), so it would not harm life, body, property, etc even a malfunction occurs. To prevent injuries and accidents, please be sure to observe the following items:

The driving current and voltage should be used below the rated value.
Please follow the terminal connection diagram for wiring. Especially for the reverse connection of the power supply, it will cause an accident due to circuit damage such as heat, smoke, fire, etc.
In order to ensure safety, especially for important uses, please be sure to consider double safety circuit configuration.
Do not apply pressure above the maximum applied pressure. In addition, please be careful not to mix foreign matter into the pressure medium. Otherwise, the sensor will be discarded, or the media will blew out and cause an accident.
Be careful when fixing the product and connecting the pressure inlet. Otherwise, accidents may occur due to sensor scattering and the blowing out of the media.
If the sensor come with sharp PIN, please be careful not to hurt your body when using it.

WARRANTY

The information in this sheet has been carefully reviewed and is believed to be accurate; however, no responsibility is assumed for inaccuracies. Furthermore, this information does not convey to the purchaser of such devices any license under the patent rights to the manufacturer. CFSensor reserves the right to make changes without further notice to any product herein.

CFSensor makes no warranty, representation or guarantee regarding the suitability of its product for any particular purpose, nor does CFSensor assume any liability arising out of the application or use of any product or circuit and specifically disclaims any and all liability, including without limitation consequential or incidental damages. Typical parameters can and do vary in different applications. All operating parameters must be validated for each customer application by customer’s technical experts. CFSensor does not convey any license under its patent rights nor the rights of others.